Renewable Heating for Business Premises: Every Option Compared
Updated 23 October 2026 · Renewable Energy for Businesses
Weighing up a heat pump or other low-carbon heating?
Request a quoteA business can heat its premises with low-carbon technology in eight main ways: an air source heat pump, a ground or water source heat pump, a connection to a heat network, a biomass boiler, an electric boiler, an electrode boiler for very large loads, solar thermal for hot water, or a hybrid that pairs a heat pump with a boiler. No single option wins everywhere. The deciding factors are the building's heat demand and fabric, the temperature the heating system needs, access to fuel or land, and the price of electricity against gas. Heat pump costs are covered in the commercial heat pump guide, which this page does not repeat.
Which low-carbon heating options can a business use?
| Option | Where it tends to fit | Check first |
|---|---|---|
| Air source heat pump | Sites with outdoor space for the unit and a heating system that can run at lower temperatures. Air-to-water units feed a wet system, air-to-air units warm rooms directly | Design flow temperature, emitter sizing and electrical capacity |
| Ground or water source heat pump | Sites with land for ground loops or boreholes, or with shared ground loops serving several units | A ground survey, and the outdoor space the loops need |
| Heat network connection | Dense urban sites near an existing or planned network, where the plant is run by someone else | The supply contract, charges, complaints route and zoning status |
| Biomass boiler | Rural sites off the gas grid with room for fuel storage and a reliable fuel supply | Local air quality, an emissions certificate and fuel availability |
| Electric boiler | Small or occasional heat loads, or sites with no room for a heat pump, ideally with heat storage and a time-of-use tariff | Running cost and supply capacity (see the electric boiler guide) |
| Electrode boiler | Very large loads and process steam | See the process heat guide |
| Solar thermal | Sites with hot water demand and roof, wall or ground space for collectors | Space for collectors and a larger hot water cylinder |
| Hybrid heat pump and boiler | Sites where a standalone heat pump is not suitable, with the boiler as top-up or for hot water | The controls logic and the running-cost assumptions behind it |
What do the main options need from the building?
CIBSE says a heat pump's efficiency depends on system design, operating temperatures, building fabric performance, emitter sizing, controls strategy and commissioning quality, and that electrical capacity, peak demand and thermal storage all need to be considered. Its guidance for large non-domestic buildings is AM17, and TM51 covers ground source systems. The Energy Saving Trust adds that poor insulation makes electric heating especially expensive to run.
The energy source decides the other constraints:
- Ground source needs outdoor space for loops or boreholes, and the Energy Saving Trust notes that boreholes usually need a specialist ground survey.
- Biomass is limited, the Energy Saving Trust says, by air quality, space and the availability of sustainable, affordable fuel. It judges most built-up areas better suited to heat networks or heat pumps, with biomass suiting some rural businesses and isolated buildings.
- Solar thermal works all year but not evenly: the Energy Saving Trust says a typical system should provide around 90% of hot water in summer, dropping to around 25% in winter, so it usually tops up another heat source.
- Heat networks shift the plant to a supplier. Gov.uk says they are often the lowest-cost low-carbon option in high density urban areas, and Ofgem regulates them in Great Britain (see the regulation guide). Zoning could eventually require some larger buildings to connect: see the zoning guide. The technical standards planned for heat networks are covered in the HNTAS guide.
How does the price of electricity against gas affect the choice?
Running cost per unit of heat is the fuel price divided by how much heat each unit of fuel delivers, which for a boiler is its efficiency. An electric boiler delivers one unit of heat per unit of electricity, which the Energy Saving Trust describes as a coefficient of performance (COP) of 1. It says heat pumps typically achieve a COP of 2.5 to 4, which is how they reduce running costs compared with direct electric heating.
DESNZ's annual report gives provisional 2025 averages for non-domestic users, across all size bands and including the Climate Change Levy, of 24.3 pence per kWh for electricity and 5.3 pence for gas. On those figures electricity costs about 4.6 times as much per kWh as gas. Actual contracts vary by size band: see the electricity price guide and the gas price guide. The electric boiler guide works through the arithmetic for each option.
Which option suits which site?
- Rural site on oil or LPG: the candidates include a heat pump, a biomass boiler or an electric boiler, and the oil and LPG replacement guide compares them. The biomass guide covers fuel and rules.
- Dense urban or multi-tenant building: a network connection may be available, and a landlord that passes heat on may itself become an operator or supplier, which brings Ofgem regulation.
- Small, occasionally used premises: an electric boiler or air-to-air heat pump may suit better than a larger wet system, because the Energy Saving Trust says direct electric systems can better suit irregular heating patterns.
- High hot water demand: solar thermal can offset part of the load, with a heat pump or boiler making up the rest. Where the site already has solar PV, the solar and heat pump guide covers the pairing.
- Poor fabric or high flow temperatures: improve the building first, or consider a hybrid while that happens. The Energy Saving Trust says a hybrid's controls should run the boiler only when it is cheaper than the heat pump.
- Large process loads: the options differ, as the process heat guide explains.
What funding and tax relief apply?
The Boiler Upgrade Scheme in England and Wales pays £7,500 towards an air or ground source heat pump (£9,000 until March 2027 where oil or LPG is replaced and there is no mains gas), or £5,000 towards a rural off-grid biomass boiler, for a building used for business, up to 45 kWth, and excludes hybrids.
For tax, gov.uk lists space and water heating systems among the integral features that go in the 6% special rate pool. Companies can claim the 50% first-year allowance on special rate expenditure, but full expensing covers main rate expenditure only. The annual investment allowance of £1 million can also apply. The capital allowances guide explains the detail. The old Renewable Heat Incentive is closed: see the RHI and Feed-in Tariff guide.
What should a business check first?
- Measure heat demand from gas, oil or LPG records and, if possible, half-hourly electricity data.
- Check the fabric and the temperature the heating system needs.
- List constraints: outdoor space, fuel storage, roof, electrical capacity and lease terms.
- Compare options using actual contract prices, not national averages.
- Read the commercial heat pump page for how that route fits the wider renewable stack. Readers can send an enquiry through the form on this page.
Sources and last checked
- Gov.uk, checked 22 October 2026: Boiler Upgrade Scheme overview, what you can get and eligibility; heat networks; capital allowance rates and pools, full expensing, permanent full expensing and annual investment allowance.
- DESNZ, checked 22 October 2026: annual report and accounts 2025 to 2026 (published 16 July 2026, updated 19 August 2026) and its performance report.
- CIBSE, checked 22 October 2026: heat pumps campaign page. Ofgem, checked 22 October 2026: heat networks and NDRHI closure.
- Energy Saving Trust, checked 22 October 2026 (guidance written for homes): ground source heat pumps, solar water heating, electric heating, hybrid heat pumps, the heat pump fact check and its response on alternative clean heating.
Guides on this topic
Common questions
What is the cheapest renewable heating option for a business?
None is cheapest everywhere. Running cost follows the fuel price divided by the heat each unit delivers, and DESNZ's average non-domestic electricity price is about 4.6 times its gas price. Upfront cost, space and tax relief differ by option, so the answer comes from a site's own contract prices and measured demand.
Can a town-centre business use a biomass boiler?
It is difficult. The Energy Saving Trust says pellet and chip boilers still emit enough pollutants to raise concerns in any area with a risk of local air quality issues, and it judges most built-up areas better suited to heat networks or heat pumps. Biomass tends to suit rural businesses and isolated buildings.
Is the Renewable Heat Incentive still available for new heating systems?
No. Ofgem records that the Non-Domestic Renewable Heat Incentive closed to new applicants in Great Britain on 31 March 2021. New systems rely on other routes, such as tax relief on the capital cost.
Are electric boilers a renewable heating option?
They are only as low-carbon as the electricity that runs them. The Energy Saving Trust says electricity is an increasingly low-carbon form of heating as more wind and solar power the grid, but an electric boiler gives one unit of heat per unit of electricity, so it uses more of it than a heat pump.