renewableenergyforbusinesses

Solar PV and a Heat Pump Together: Does the Pairing Pay for a Business?

Updated 23 October 2026 · Renewable Energy for Businesses

Planning solar panels for your building?

Request a quote

Pairing solar PV with a heat pump can lower a business's electricity bill, but it rarely covers winter heating. A solar array produces most of its energy in summer, a heat pump does most of its work in winter, and a Government Office for Science note says winter solar output falls to about an eighth of a typical June day. The pairing pays best where heat demand continues through the day and year, as with hot water, or where cooling and daytime shoulder-season heating overlap with generation, and a battery or thermal store widens the overlap. The practical test for a site is to line up half-hourly heat pump load against half-hourly solar output.

Does solar PV make a heat pump cheaper to run?

Only the solar electricity the heat pump actually uses on site changes its running cost. Power that is exported is paid under the Smart Export Guarantee (SEG), which Ofgem says is calculated from export meter readings at a rate set by each licensee, always above zero. Power the heat pump takes straight from the array replaces a kWh that would have been bought. DESNZ's annual report gives a provisional 2025 average of 24.3 pence per kWh for non-domestic electricity, across all size bands and including the Climate Change Levy.

The saving per kWh is therefore the import price avoided less the export rate given up. Because each licensee sets its own export rate, the gap is specific to the site's contracts, and the electricity price guide explains how import prices vary. The arithmetic that matters is how many of the heat pump's kWh coincide with spare generation.

Why does the seasonal mismatch limit the saving?

The Government Office for Science note says that in winter solar generation drops to an eighth of what a typical June day would give. The Energy Networks Association, describing its Heat Balance project, points to the huge seasonal variation in demand for heat. The two curves run in opposite directions.

SeasonHeat pump loadSolar outputOverlap
WinterHighest: space heating and hot waterLowest, around an eighth of a June dayPoor. Most heat comes from the grid or a battery
Spring and autumnBetween the twoBetween the twoOften the best window for daytime space heating
SummerHot water, plus cooling if the unit is reversibleHighestGood for hot water and cooling, but the load is small

A rooftop array sized to a site's existing load is therefore likely to meet only a small part of a winter heat pump load. That does not make the pairing a poor one, but it means the case rests on shoulder seasons, hot water and cooling rather than on December.

Where does the pairing work best?

  • Hot water. It continues through summer, when the array produces most. CIBSE describes heat pumps as able to provide heating, cooling and hot water for commercial buildings.
  • Cooling. CIBSE says a heat pump operated in reverse removes heat in the same way as an air conditioner, so a reversible unit can use summer sun for cooling.
  • Daytime use. A building occupied on weekday daytimes uses more of its load while the sun is up than one that heats overnight. This is reasoning from the shape of the load, not a measured figure, which is why half-hourly data matters.
  • Storage. The Energy Saving Trust modelled around 1.1 million combinations of heat pump, solar, battery and tariff using data from 546 homes. It found batteries performed better paired with a heat pump than with solar panels, provided the tariff suited, and that the tariff mattered as much as the technology. Those results are for homes, so a business should test the same question against its own half-hourly or flexible contract: see the half-hourly settlement guide and the fixed or flexible contract guide.
  • Controls. The Energy Saving Trust notes that some hybrid heat pump systems have controls that react to whether solar panels are generating or exporting electricity.

The wider case for solar, battery and charging as one system is in the integrated system guide, and the electrical headroom for adding heat is in the site electrification guide.

How can a business estimate the heat pump's share of the solar output?

  1. Get 12 months of half-hourly import data for the site. Monthly bills are a poor substitute because the timing is what matters.
  2. Estimate annual heat demand from gas, oil or LPG records, then divide by the heat pump's expected seasonal COP to get its annual electricity use. The Energy Saving Trust gives a typical COP of 2.5 to 4 for homes, and a designer should give a site-specific figure.
  3. Spread that electricity over the year in line with heating need and occupied hours.
  4. Obtain a half-hourly generation profile for the proposed array from its designer.
  5. In each half-hour, take the smaller of the heat pump load and the solar output left after the site's other load. Add these up for the year.
  6. Divide that total by the array's annual output for the heat pump's share of the solar, and by the heat pump's annual use for the share of its load that solar covers. Value those kWh at the import price avoided less the export rate given up.

For example, take a hypothetical 2,000 square metre warehouse that burns 150,000 kWh of gas a year for heating. At a COP of 3 a heat pump would use 50,000 kWh of electricity. If the overlay shows 12,000 kWh of that falls in half-hours with spare solar, solar covers 24% of the heat pump's load. If the array generates 100,000 kWh a year, the heat pump absorbs 12% of its output. These numbers are invented to show the method and are not a forecast.

What do the tax rules and funding say about the pair?

Gov.uk lists both solar panels and space and water heating systems (an integral feature) among the assets that go in the 6% special rate pool. Both can be covered by the annual investment allowance, which is £1 million for each accounting period and shared across everything claimed in that period. A company can claim the 50% first-year allowance on special rate expenditure, but full expensing covers main rate expenditure only. The capital allowances guide sets out the detail.

In England and Wales the Boiler Upgrade Scheme pays £7,500 towards an air or ground source heat pump in a building used for business, which covers the heat pump itself. The commercial heat pump page covers the heat side of the stack, the commercial solar page the generation side, and readers can send an enquiry through the form on this page. The renewable heating comparison sets the pairing against the other heating options.

Sources and last checked

Common questions

Can a heat pump use solar power directly?

Yes. The Energy Saving Trust describes diverting solar generation to electric heating directly when possible, and via a battery at other times. Whatever the array cannot supply is imported, and any surplus is exported and paid under the Smart Export Guarantee.

Does a battery help a heat pump?

It can. The Energy Saving Trust's modelling for homes found batteries paired better with heat pumps than with solar panels, assuming the right tariff. The benefit comes from charging at cheaper times and discharging into the heat pump load, so a business needs a half-hourly or flexible contract to get the same effect.

Can a heat pump use summer sun for cooling?

A reversible heat pump can. CIBSE says a heat pump operated in reverse removes heat in the same way as an air conditioner. A unit chosen for both duties can therefore put summer generation to use when the heating load is small.

Does the Smart Export Guarantee pay for solar that the heat pump uses?

No. Ofgem says SEG payments are calculated from export meter readings, so only electricity sent back to the grid earns a payment. Solar used on site by the heat pump earns no SEG payment but avoids buying that electricity.

Request a renewable energy for businesses quote

By submitting you agree to our privacy policy. We never sell your details.

Related guides

Request a quote
Request a quote